The set consist of 2 upper and 2 lower rollers of Ø38 x 160 mm. The test assembly is used for 3 or 4 point flexural tests on 100 or 150 mm Concrete Beams. Can be connected to HİRA Compression Machine or Hydraulic Power Packįlexural Testing Assembly for Concrete Beams.Can accept wide range of accessories for mentioned standards.High accuracy load measurement with load cells.The load frame provides the stability needed for accurate and repeatable test results over the years of operation.Īll frames can be connected to HİRA compression machine as a second frame or can be used with any HİRA power pack as an independent Flexural Machine. The very rigid C type design is ideal either for conventional flexural test or for more sophisticated tests such as deformability and ductility index. A load cell is used for load measurements on all frames.įlexural Frames are designed to accept all accessories required for flexural or compression tests.įlexural Frames are 100 kN, 200 kN, 300 kN capacity U Type and 300 kN, 400 kN capacity C Type open structure designed to allow easy and practical front loading of the specimen. All Frames have a single acting up stroking ram with over travel switch protection to stop the machine when maximum ram travel is reached. The load frame is a welded steel fabrication carrying the ram fitted to the steel base. The multipurpose HİRA Flexural Testing Frames are designed for minimum deflection at maximum load resulting in very high accuracy. The Automatic Flexural Testing Machines consist of ĭigital data acquisition & control system,įlexural test assemblies should be ordered separately. The HİRA ranges of Flexural Machines have the accuracy of Class 1 starting from 2% of the full capacity. Automatically saves the test parameters and test results.The machine automatically starts the rapid approach, switches the test speed after 1% of the load capacity of the machine and stops once the specimen failure. Pressing the START button on the control unit.Setting test parameters, including pace rate (only required when the specimen type is changed).Once the machine is switched on and the specimen is placed. The Automatic Flexural Testing Machines allow inexperienced operators to perform the tests. Tests can be performed by either Digital Readout Unit or on a computer with using free Software. These also meet the requirements of CE norms for the safety and health of the operator. Machines confirm all EN, ASTM and BS standards written above. The HİRA Automatic range of 100 kN, 200 kN, 300 kN and 400 kN capacity Flexural Testing Machines have been designed for reliable and consistent testing of flexural test on standard concrete beams, concrete or natural stone kerbs, concrete paving flags, and natural stone slabs and tensile splitting test of concrete paving blocks with suitable apparatus.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |